Go to documentation repository
...
The connection settings table can be accessed from the Architecture tab. This table is used to configure the connection between computers in the distributed system and distribute the information about the events registered in the system. The connection settings table is shown in the figure.
...
№ | Column | Description | Value |
1 | Computer | Network name of the computer | Defined Determined by the OS |
2 | Name | Computer name in the system | Set in the Hardware tab |
3 | Connection | Checkbox | If the checkbox is set—the —the computer is connected If the checkbox is clear—connection wasn't established |
4 | With computer | List of names of the network computers | Defined Determined by the OS |
5 | IP address | IP address of the computer in the local network (if connected via the internet, then public IP address) | Defined Determined by the OS or assigned manually. When the IP address of the Server/RAW server/remote administrator's workstation is edited, the IP address for the current Server/RAW server/remote administrator's workstation only is changed. For other Servers/RAWs servers/remote administrator workstations, the IP addresses must be changed individually. If the entered address is already assigned to a computer in the system, the address is assigned to the computer being configured, and the corresponding warning message is displayed. The address of the computer that previously had this address is reset |
6 | Send events | Checkbox | If the checkbox is set—there is a permission to send events to the computer it is connected to If the checkbox is clear—there is no permission to send events |
7 | Type | List of the system objects, from which the events are transmitted to the selected computers | Defined Determined by the list of the registered objects |
8 | Event | Checkbox in the list next to each item in the event list, corresponding to the device selected in the Type column | If the checkbox is set—this event is transmitted If the checkbox is clear—this event isn't transmitted |
| Info | ||
|---|---|---|
| ||
To enter the IP address of the computer of a distributed system, enter the "?" character in the IP address column while holding down the Shift key. After this, you must restart Axxon PSIM. |