Setting up a connection between ATM Intellect Pro and ATM Intellect Workstation

Setting up a connection between ATM Intellect Pro and ATM Intellect Workstation is performed in the following way:

1. Go to the Surveillance Object object setting panel.
   
2. Click the Transmitting ... button. A dialog box for selecting the interface method between ATM Intellect Pro and ATM Intellect Workstation opens.
   
3. In the Connection to ATM Intellect Workstation drop-down list select one of the two available methods for connecting ATM Intellect Pro to ATM Intellect Workstation will be used: Server mode or Client mode (1).
   1. In the Connection type drop-down list select the type of transport interface. Can be either TCP/IP or RS232 (2).
   2. If RS232 is chosen for the Connection type, the COM port number, COM port speed and COM port format must be configured (3).
   3. If TCP/IP is chosen for the Connection type, in the TCP port enter the number of port for TCP/IP connections (4).
      If Client mode has been chosen for the connection to ATM Intellect Workstation and TCP/IP has been chosen for the Connection type, in the dialog box, indicate the   IP address and TCP port of ATM Intellect Workstation.
4. The sending of frames and clips on ATM-Intellect Workstation is performed by packets. The I/O buffer (bytes) field sets the packet size (5). For maximum transmission speed, use 4096. It is recommended to use value 800 for bad connection links, for example when the GSM-modem is in use.
5. In the Ping frequency (sec) field enter the frequency at which ATM Intellect Pro sends ping test messages about its technical status to ATM Intellect Workstation  (Client mode) - (6). Minimal possible value is 10 sec. The value in the Ping frequency (sec.) field does not affect short-term alarms. Messages about short-term alarms are transmitted to ATM-Intellect Workstation immediately after corresponding sensors triggering. Some long-term alarms can also be an exception: for more info, see the document ATM-Intellect. Operator's Guide, section Appendix 1. Data update periods summary
6. Click OK (7).

Setting up a connection between ATM Intellect Pro and ATM Intellect Workstation is completed.