To start generating the report, click the System faults button.

A dialog box then appears, with the parameters necessary for report generation.

This dialog box allows setting the following report parameters:

1. Time period for the report. Use the Beginning date, Beginning time, End date, and End time parameters for this.
2. Object description. This setting allows switching between the two report modes:
   1. Report on all system objects
   2. Report on one system object
      
3. Failure type. This setting allows specifying the type of fault for which you want to generate a report. You can also create a report for all faults that occurred during a specified interval of time.
   
4. Sorting. A report can be sorted in one of two ways:
   1. By events ("cameras", "archive", etc).
   2. By time of event start
      

After configuring all parameters, click OK. The report appears in a new window.

The same report, generated for a single object, looks as shown in the figure.

Each report window has a toolbar.

The Save report and Open report buttons are worthy of special attention. If the ATM Monitoring Reports component cannot access a printer or the report must be saved electronically for later viewing, you can save the report as a file with the .frp, .xls, .xml, .rtf, or .html extension. This file can later be opened on another workstation.