You can configure a Hikvision alarm output via the settings panel of the Hikvision alarm output object, which is automatically created on the basis of Hikvision 26X or Hikvision 28X object after reading the configuration from the corresponding controller (see Network settings of the Hikvision controller and Configuring the Hikvision controller ). As an example of Hikvision alarm output configuration, let's consider an alarm output created on the basis of the Hikvision 26X object.

You can configure the Hikvision alarm output as follows:

1. Go to the settings panel of the Hikvision 26X Alarm Output object.
   
   
2. In the Number drop-down list (1),  you see the alarm output's ID number corresponding to its ID in the Hikvision controller. You can not change this value.
3. In the Relay Name (2) field, enter the alarm output name under which it will further appear in the Intellect PSIM.
4. In the Output Delay, s field (3), enter the desired delay time for your alarm output.

The Hikvision alarm output is now configured.