To configure the Hikvision user cards, do the following:

1. Go to the user editing in the Access Manager module (see Going to user editing).

2. In the advanced options tab, select the Hikvision extention parameter and click the button. 
   
   The Hikvision extended user options window opens.

   If the Hikvision extention parameter isn't displayed, enable it for user accounts (Configuring fields displaying in user accounts).

   

3. Select the required Hikvision controller from the objects tree.

4. From the Card type drop-down list, select the card type:

   1. Invalid—expired card.
   2. Ordinary card—standard card type.
   3. Disabled card—swiping this type of card prevents the door from locking for a time interval specified by the Unlock Time for Disabled Pass parameter (see Configuring the Hikvision door).
   4. Blacklist card—when a blacklisted card is swiped, a system event is generated without granting access.
   5. Patrol card—this type of cards can be used by supervisors.
   6. Stress card—if a user is under duress, this card opens the door and generates a duress alarm.
   7. Super card—this card opens all doors of a given controller/terminal within an active time zone specified for user's access level.
   8. Visitor card—the card is intended for visitors. You can set the maximum number of swipes for this card in the Max count of swipe field (see step 6).
      
      

      
      

5. Set the Leader card checkbox (2) if it is necessary to activate all readers connected to this controller/terminal by the first card swipe through any of the readers.

6. Set a limit for a number of Visitor card swipes in the Max count of swipe field. The maximum number of swipes must be in the range from 0 to 255. The 0 value means that there are no restrictions on the number of swipes.

7. Specify a card password in the Auth. pass field. The password consists of 4 to 8 digits. The availability of this parameter setting depends on the Hikvision controller/terminal model.

8. From the Verify mode drop-down list, select the mode in which the user's card works.

   For the correct operation, the device must support the selected verification mode.

   
   

9. In the card group area, select the required card groups by setting the checkboxes next to them. The availability of this parameter setting depends on the Hikvision controller/terminal model.
   
10. Click the Apply button to apply the settings and return to the user editing menu.
11. In the user editing menu, click the Save button to save the changes.