Page History

The Vehicle Tracer interface window includes the following components:

1. Active monitor – is designed for displaying is used to display the data about the identified plates, processing process the alarm events;
2. Events monitor – displays a video frame with a vehicle, which plate is being identified at the moment, and also a speed and a number.
3. Alarm window - is designed for displaying is used to display the data about vehicles, in case of coincidence of the recognized plates with match the plates which that are stored on the external orientation database.

...

1. Go to the Vehicle Tracer settings panel.
   
2. Select the required tab of the corresponding Vehicle Tracer component (1):
   • Basic tab - corresponds to the Active monitor component.
   • Monitor tab - corresponds to the Events monitor component.
   • Alarm window tab - corresponds to the Alarm window component.
3. Set the Show checkbox (2) if it is necessary to display the selected component on the screen.
4. Set the coordinates of the left upper corner of the selected component (3):
   • Field The X field (horizontal indent from the left border of the computer 's screen).

   • Field The Y  field (vertical indent from the upper border of the computer 's screen).

     Info
     title Note
     The coordinates are set in percentage in according to screen 's size horizontally and vertically, respectively.

     
     

5. Set the sizes of the selected component on the screen (4):
   • Field The W  field(component's width).

   • Field The H field (component's height).

     Info
     title NotesNote
     The coordinates are set in percentage in according to screen 's size horizontally and vertically, respectively. Minimum sizes of the Active monitor component are 70% horizontally (W) and 39% vertically (H). To ensure the Operator's efficiency, avoid the mutual overlapping of components. To set the coordinates and sizes of the selected component component in a convenient way, it is recommended to use the visual method of setting up the coordinates. Click the  button for this (5) and, using the mouse, set the required size and position of the test window and then click  the OK button. Coordinates of the test window are automatically calculated and copied to the fields X, Y, W and H fields.

     

6. Set the Allow moving checkbox (6) if it is necessary to allow moving the component across the screen.
7. From the Monitor drop-down list, select the number of the physical monitor connected to the computer on which the selected component should be displayed.
8. Click  the Apply  button to save the changes (7).

Setting up the position of the Vehicle Tracer components on the screen is complete.