Setting up the position of the Vehicle Tracer components on the screen

The Vehicle Tracer interface window includes the following components:

1. Active monitor – is designed for displaying the data about the identified plates, processing the alarm;
2. Events monitor – displays a video frame with a vehicle, which plate is being identified at the moment, and also a speed and a number.
3. Alarm window - is designed for displaying the data about vehicles in case of coincidence of recognized plates with plates which are stored on the external orientation database.

To set up the Vehicle Tracer components position on the screen, do the following:

1. Go to the Vehicle Tracer settings panel.
   
2. Select the required tab of the corresponding Vehicle Tracer component (1):
   • Basic tab - corresponds to the Active monitor component.
   • Monitor tab - corresponds to the Events monitor component.
   • Alarm window tab - corresponds to the Alarm window component.
3. Set the Show checkbox (2) if it is necessary to display the selected component on the screen.
4. Set the coordinates of the left upper corner of the selected component (3):
   • Field X (horizontal indent from the left border of the computer's screen).

   • Field Y (vertical indent from the upper border of the computer's screen).

     Note

     The coordinates are set in percentage in according to screen's size horizontally and vertically respectively.

5. Set the sizes of the selected component on the screen (4):
   • Field W (component's width)

   • Field H (component's height).

     Notes

     • The coordinates are set in percentage in according to screen's size horizontally and vertically respectively.
     • Minimum sizes of the Active monitor component are 70% horizontally (W) and 39% vertically (H).
     • To ensure the Operator's efficiency, avoid the mutual overlapping of components.
     • To set the coordinates and sizes of the selected component in a convenient way, it is recommended to use the visual method of setting up the coordinates. Click  button for this (5) and, using the mouse, set the required size and position of the test window and then click OK. Coordinates of the test window are automatically calculated and copied to the fields X, Y, W and H.

     

6. Set the Allow moving checkbox (6) if it is necessary to allow moving the component across the screen.
7. From the Monitor drop-down list, select the number of the physical monitor connected to the computer on which the selected component should be displayed.
8. Click Apply to save the changes (7).

Setting up the position of the Vehicle Tracer components on the screen is complete.