Page History

If a camera has a built-in or pluggable digital input, theThe Input object is displayed as a child object of the Camera in object in the object tree if a camera has a built-in or pluggable digital input. The total number of of Input objects for a camera corresponds to its the number of pluggable digital inputs a camera has.

If a device is defined as an IP Server, Input will be server, an input is displayed as a child object of a a Channel object in the object tree (see The Channel object).

To configure a the Input object object, perform do the following:

1. Go to the Devices tab.
2. Select
the
3. the Input object in the
objects tree (1).
Image RemovedEnable the device (2).
4. object tree. If necessary, you can change the values of the parameters that are listed in the table:
   

   Parameter	Value	Description
   Other
   Enable	Yes	By default, the input is disabled. To enable it, select Yes
   	No
   Name	Input	If necessary, enter the input name
   Input/output ID	0 (non-editable field)	Input/output ID for the input on the controller
   Normal status	Open	From the drop-down list, select the status of the input in which it must be when there is no alarm
   	Closed
   Camera
   Camera	{Short name.Name}	From the drop-down list, select the camera with which you want to bind the input (see Camera). As a result, the input becomes a child of the selected camera Info title Note If

a

5. the input is a child of

a

6. the Channel object, then:

7. Turning on a input automatically enables its parent Channel object.
Turning off

8. When you enable the input, the Channel parent object is automatically enabled. When you enable all Input and Output child objects

automatically disables their parent Channel object.
9. Enter the name of the Input (3).
Set the status to which the Input will be set when no alarm is present.
Image Removed

10. , the Channel parent object is also enabled.

11. Click the Apply
button
12. Image Added button.

The Input will then be switched to its assigned work As a result, the input is switched to the specified operating mode.

The current status state of the Input input is displayed in the Input information group.Image Removed

If a Input is part of an IP server, the Input settings allow choosing the video camera of the IP server it will be matched to. When you do this, the Input object will appear as the child object of the specified camera in the object tree.

Image RemovedImage Added