Configuring the Satel2 ETHM-A integration module

Configuration of Satel2 ETHM-A integration module is performed by configuring two system objects: Satel Ethma TCP Service object and Satel Ethma child object.

Configuring Satel Ethma TCP Service object

To configure the Satel Ethma TCP Service object, do the following:

1. Select the main Satel Ethma TCP service object.
   
2. In the Polling time [s] field, enter the value specified when configuring the Satel2 ETHM-A universal monitoring module via GX Soft tool.
3. In the VMS IP address, specify server IP address used to connect Axxon One with the Satel2 ETHM-A universal monitoring module.
4. In the VMS Port, specify the port used to connect Axxon One with the Satel2 ETHM-A universal monitoring module.
   

   Attention!

   Make sure the firewall is configured to allow traffic from the Satel2 ETHM-A universal monitoring module to Axxon One server.

   
   

   Note

   The values need to be kept consistent with the ones specified when configuring the Satel2 ETHM-A universal monitoring module via GX Soft tool (see Preparing the Satel2 ETHM-A universal monitoring module to work with Axxon One).

5. Click the Apply button to save the settings. 
6. Click the  button, and from the drop-down list select Download configuration from device.
   
   
7. Click the Apply button.

As a result, Satel Ethma object will be created.

Configuring Satel Ethma child object

To configure Satel2 Ethma object, do the following:

1. In the Device IP field, enter the Satel2 ETHM-A universal monitoring module IP address.
2. In the Input AC number field, specify the amount of AC inputs configured in Satel2 ETHM-A universal monitoring module.
3. In the Number of 1-Wire sensors field, specify the amount of sensors configured in Satel2 ETHM-A universal monitoring module.
   

   Note

   In order to determine the amount of inputs and outputs to be selected, refer to the Input/Output preview section on the page Preparing the Satel2 ETHM-A universal monitoring module to work with Axxon One

4. In the Number of inputs field, specify the amount of inputs configured in Satel2 ETHM-A universal monitoring module.
5. In the Number of outputs field, specify the amount of outputs configured in Satel2 ETHM-A universal monitoring module. 
6. Click the Apply button to save the settings.
7. Go to the Satel Ethma TCP Service object.
8. Click the  button, and from the drop-down list select Download configuration from device.
9. Click the Apply button.

As a result, the available inputs, outputs and sensors will be added to the Satel Ethma object device tree.