The settings panel of the Testing video capture cards section

The Testing video capture cards section is designed to test the connection of cameras to the video capture card.

Note

To use this functionality, you must shut down Axxon PSIM. If it is running, the message Cards not found is displayed.

The settings panel of the Testing video capture cards section is shown in the figure.

The description of the setting parameters of the Testing video capture cards section is given in the table.

No	Parameter name		The way of specifying the parameter value	Description	Representation	Default value	Value range
1	The Board drop-down list		Select the value from the list	Specifies the video capture card to which the camera connections must be checked	List of video capture cards	NA	Depends on the number of installed video capture cards
2		The Test button	Click the button	Starts the testing process of the video capture card. The testing is performed when you shut down Axxon PSIM	NA	NA	NA
The Channels state table
3	The Channel column		Automatically	Displays the channel numbers of the selected video capture card	NA	NA	From 1 to 16
4	The State column		Automatically	Displays the state of the cameras' connection to the channels of the selected video capture card	NA	NA	Connected—camera is connected Disconnected—camera is disconnected

If the video capture card isn't recognized by the tweaki.exe utility, we recommend checking whether the camera access is allowed for applications. For this, do the following:

Go to Windows Settings→ Privacy→ Camera.
Allow apps to access your camera by setting the switch to the On position as shown in the figure below.

Page tree

Documentation for Axxon PSIM 2.0. Documentation for other versions of Axxon PSIM is available too.